🇦🇫 Afghanistan · Doors & windows · Updated 2026
How much doors and windows do you need to build a house in Afghanistan?
A 150 m² single-storey house in Afghanistan needs roughly 24 no. of doors and windows — about 0.16 no. per m² of floor area. That is computed from Afghanistan construction conventions, including the local wastage allowance.
Doors & windows quantities for a house in Afghanistan, computed from how buildings are actually put up here rather than from a global average. The tables below run from a small 50 m² dwelling to a 400 m² family home, and the method section shows how to reproduce every figure by hand so you can adapt it to your own plan.
Doors & windows by house size in Afghanistan
| Floor area | Doors & windows required | Per m² of floor |
|---|---|---|
| 50 m² | 9 no. | 0.18 |
| 75 m² | 13 no. | 0.17 |
| 100 m² | 17 no. | 0.17 |
| 150 m² | 24 no. | 0.16 |
| 200 m² | 32 no. | 0.16 |
| 250 m² | 39 no. | 0.16 |
| 300 m² | 47 no. | 0.16 |
| 400 m² | 63 no. | 0.16 |
Single-storey. The per-m² rate falls as the house grows — a small house has more wall and roof per square metre of floor than a large one, which is why these are computed size by size rather than scaled from a single rate.
Where it goes — 150 m² house
Doors ~1 per 12 m² of floor area | 13 no. |
Windows ~1 per 14 m² of floor area | 11 no. |
What drives the quantity in Afghanistan
| Factor | Local value | Effect |
|---|---|---|
| Standard door | 900 × 2100 mm | The size stocked locally. Non-standard sizes are made to order and cost disproportionately more. |
| Standard window | 1500 × 1200 mm | Sets the lintel length and the opening deduction in the masonry quantity. |
| Bathroom window | 600 × 600 mm | Small and high-level for privacy — usually a different unit from the rest. |
| Door density | 1 per ~12 m² | Derived from typical room counts at this floor area. |
| Window density | 1 per ~14 m² | Habitable rooms need light and ventilation; service rooms need less. |
How to calculate it yourself
- 01
Count openings off the plan room by room — this is one quantity you should never estimate from area if a drawing exists.
- 02
As a check, a house of this size normally has about one door per 12 m² and one window per 14 m².
- 03
Schedule each opening with its size, material, handing and ironmongery — the schedule, not the count, is what a joiner prices.
- 04
Measure lintels over every opening: the width plus a bearing each side.
Buying and site notes
- —Order frames early. Joinery lead times routinely exceed the masonry programme and hold up plastering.
- —Fix frames before plastering so the plaster closes onto them — the alternative is a visible gap filled with sealant.
- —Check that door swings do not clash with each other or with switches before the frames are built in.
Get every material measured off your own plan
This page works from a representative footprint. Upload your dimensioned drawings and get the full schedule — every material, measured from your real geometry and priced in AFN (؋).
Take off my drawingsDoors & windows in Afghanistan — frequently asked
How much doors and windows does a house need in Afghanistan?
+
A 150 m² single-storey house in Afghanistan needs roughly 24 no. of doors and windows — about 0.16 no. per m² of floor area. That is computed from Afghanistan construction conventions, including the local wastage allowance.
How much doors and windows per square metre in Afghanistan?
+
About 0.16 no. per m² of floor area for a single-storey house. The figure is not linear across sizes — a small house has proportionally more wall and roof per m² of floor than a large one, which is why the table above is computed size by size rather than scaled from one rate.
What changes the quantity of doors and windows needed?
+
Standard door (900 × 2100 mm) — The size stocked locally. Non-standard sizes are made to order and cost disproportionately more. Standard window (1500 × 1200 mm) — Sets the lintel length and the opening deduction in the masonry quantity. Bathroom window (600 × 600 mm) — Small and high-level for privacy — usually a different unit from the rest.
Is wastage included?
+
Where it applies, yes — a 5% allowance is carried on the perishable materials (walling units, tiles, paint). Bulk materials like sand and stone carry handling loss instead. Ordering the theoretical quantity with no allowance reliably means a second delivery at a worse price.
How accurate is this for my own house?
+
It is a planning quantity derived from a representative rectangular footprint, so it is the right order of magnitude and internally consistent — good for budgeting and for checking a supplier's list. It is not a measured takeoff of your plan. Upload your dimensioned drawings to get quantities measured off your real geometry and priced in AFN.
Are doors and windows prices included?
+
No, deliberately. Material prices in Afghanistan move week to week and vary by region, so a price printed on a static page would be wrong within a month. This page gives you the quantity — take that to two or three local suppliers and the price will be current and competitive.